Top Ceiling Insulation Mistakes And How To Avoid Them

When it comes to attic insulation, there are quite a few things that you need to keep in mind. If you don’t take proper care, chances are your ceiling may not be properly insulated, and you may waste a lot of energy. Here are some of the common mistakes that attic insulation providers make, which needs to be avoided. Homeowners need to look through the symptoms and make the call at the right time, so that the contractors can ensure minimal loss of energy.

• The first thing you need to remember is that ceiling insulation removalshould be your last resort, only if all the other things fail. The first aspect of energy loss could be attributed to the insulation. However, there is more to the energy loss. The air sealing is also responsible for the energy loss. When you think through this issue, you need to consider both new construction, as well as the buildings that exist. If you find any open cracks of holes in the building, you need to seal it immediately. You can also use the fire barrier caulks when needed to seal the air.
• The framed soffits along the floor below the attic are left open by the contractors. You need to cover them with rigid insulation
• You need to close the spaces that exist between the attic floor framing and the chimneys. The gap should be just how much is mandatory for proper insulation. During ceiling insulation Brisbane, make sure you don’t seal the air using fiberglass or cellulose insulation methods
• One of the most important considerations before you opt for any rework on the ceiling is to check if there are gaps in the existing insulation. The insulation generally stops the conductive flow of heat, and a small gap that exists in this space can reduce the insulating ability of the material. In case there are gaps in the existing insulation, then you ought to fill in those gaps and ensure that the insulation has complete contact with the attic floor.
• Before opting for ceiling insulation removal, you ought to ensure that the eave vents are insulated. This will prevent mold, condensation and reduce the overall damage done to the building components. With proper insulation along the eaves, you can stay assured that the air vents are open and the insulation does not move out of the position
• In case you are installing the traditional can lights, then you need to make sure there is at least 3 inches space. You can keep a barrier between the light and the ceiling to keep the space. However, this can use up a lot of your energy. The other way to go about it would be replacing these can light with IC-rated fixtures which are airtight. You can cover it with insulation or caulk it along the trim and the ceiling, thus ensuring airtight spaces. You can even cover the existing fixture with a fireproof cap.

The idea is to have a proper ceiling insulation Brisbane which reduces the energy consumed, and improves the overall efficiency of your home.